Rent Telescopic Boom Lifts in Brandenburg: 26 Models up to 56.90 m

You can rent telescopic boom lifts from us for jobs anywhere in Brandenburg: 26 models with 14.00 to 56.90 m working height and up to 27.43 m horizontal outreach. The state is flat but spread out, and in many places the ground is sandy. Logistics halls along the Berlin Ring, industrial sites in Lusatia, listed buildings in Potsdam and bridges over the Havel, the Spree and the canals each place different demands on the machine. What matters is therefore rarely the height alone, but how far the working point lies from a firm set-up position and what the ground there can carry. We agree these three values with you before the telescopic boom lift leaves Passau.

Horizontal outreach determines how far away from the working point the telescopic boom lift may stand. All values come from the data sheets of the rental machines currently listed. You will find the individual models in the category Rent Telescopic Boom Lifts.

Over water and embankments, every metre of outreach counts

At bridge abutments, bank reinforcements, locks and boathouses, the machine usually stands on firm ground at the top while the working point lies far out in front. The largest outreach in the rental fleet is offered by the Genie SX-135XC with 27.43 m horizontal outreach, 43.15 m working height and 454 kg platform capacity. For the highest points, such as silos or chimneys, the Genie SX-180 with 56.90 m working height is available.

For hall facades, the mid-range is usually enough

Nine models with 20.60 to 22.95 m working height are available, including the Genie S-65, JLG 660SJ and Manitou 220 TJ Plus. With them you reach eaves, skylights and parapets of typical logistics and commercial halls without blocking the apron with a large machine.

Depending on the model, telescopic boom lifts weigh between 5,900 kg (Haulotte H14TX) and 24,856 kg (Genie SX-180). When the boom is extended, the load also shifts onto individual wheels. On loose sand, in low-lying areas with high groundwater and on freshly backfilled utility trenches, the ground is therefore more often the deciding factor than the height.

1. Name the type of ground: State in your enquiry whether the machine will stand on asphalt, paving, gravel, compacted or loose sand. The model and the packing material depend on this.
2. Plan load distribution: On unpaved areas, load distribution plates or a gravel site road spread the wheel loads. Clarify the permissible surface load on slabs, basements and underground car parks with the structural engineer in advance.
3. Take the weather into account: After longer periods of rain, sand loses bearing capacity and cohesive soils become soft. Check the set-up area again on the day of use.

For soft ground, it is worth asking about the Trax versions of the Genie S-65 (21.80 m, 12,269 kg) and the Genie S-65XC Trax (21.81 m, 13,154 kg, 454 kg platform capacity). We check whether their undercarriage suits your area based on your details.

Which type you need depends on what lies between the set-up position and the working point.

• Telescopic boom lift: The path is clear but long. The straight boom takes the platform directly up and out, for example over an apron, an embankment or a stretch of water.
• Articulating boom lift: An obstacle is in the way, such as a roof edge, a pipe bridge or a row of trees. The knuckle guides the platform over it and back down behind it.
• Spider lift: The access is narrow or the ground is sensitive, for example in courtyards, parks and on lawns. Spider lifts are light and fit through gates, but reach less height and outreach.

Three models run on electric drive: the Zoomlion ZT18JE-Li (20.60 m), the ZT21JE-Li (22.95 m) and the Zoomlion ZT26JE (28.70 m). In addition, there is the Genie S-60 FE (20.60 m) with hybrid drive. The electric machines are locally emission-free in operation and low-noise. This helps in closed or partly open halls, in logistics centres with ongoing operations and on residential buildings in Potsdam and around Berlin. If the operator of the site prescribes a drive type, please state it in your enquiry.

We deliver the telescopic boom lifts from our location in Passau. Depending on the job site in Brandenburg, the distance from Passau is around 550 to 700 km. Over this distance, transport carries more weight than on short routes. Plan the start and end of the rental early and combine jobs that need the same machine.

Clarify access and unloading point in advance

Large telescopic boom lifts arrive on a low-loader. Tell us about narrow points, clearance heights, turning radii and weight restrictions on farm and forest tracks, as well as a paved unloading point. Especially for jobs away from the towns, the last stretch of the route decides how smoothly things run.

You will find further machines for the region on the pages Brandenburg, Potsdam, Cottbus and Frankfurt (Oder). For jobs in the capital, see the page Telescopic Boom Lifts in Berlin.

We hand over every telescopic boom lift with a valid inspection certificate. The company that uses the machine is responsible for its safe use on site.

• Risk assessment: Under Section 3 of the German Ordinance on Industrial Safety and Health (BetrSichV), you assess the hazards at the workplace before use, such as ground, wind, overhead lines and traffic.
• Operators: The machine may only be operated by persons who have been trained in accordance with DGUV Principle 308-008 and who have been instructed and authorised in writing in accordance with Section 12 BetrSichV.
• Fall protection: Persons in the platform wear a full-body harness attached to the designated anchor point.
• Permits: For pavements, parking lanes or carriageways you need a permit from the responsible authority. For work on or over federal waterways, you also coordinate with the responsible Waterways and Shipping Office (WSA).

Tell us the job site, working height, distance to the working point, type of ground and rental period. We will suggest the right model and plan the transport from Passau. Contact us now