Rent aerial work platforms and construction machinery in Wetzikon

Renting aerial work platforms and construction machinery in Wetzikon means, in most cases, working while operations continue. As the regional centre of the Zurich Oberland, the town concentrates public service buildings that never come to a complete standstill — healthcare buildings, school complexes, administrative properties — and alongside them commercial zones at a heavily used traffic junction. Where patients, school classes or customers are in the building, it is noise, exhaust fumes, cleanliness and the available time window that decide the choice of machine, not the maximum working height. Luibl delivers inspected hire machines for this to Wetzikon and the Oberland on its own low-loader.

In a hospital or a care facility, the building site is a guest. The corridor remains an escape route, the adjoining room remains in use, and the working time cannot be freely chosen. In practice we always rely on electric drive here: electric scissor lifts from 6.30 m working height are locally emission-free, run on non-marking tyres and are quiet enough to work on an occupied floor. For alterations in examination and treatment rooms where every square metre is taken, a mast lift with 10.00 to 12.65 m working height and 200 kg platform capacity is often the only machine that fits into the room at all — it goes through standard doors, weighs little and can be repositioned by one person.

Plan the assignment backwards from the time window. In healthcare buildings, work is frequently carried out section by section: one wing, one floor, one night. The machine should be brought in, cleaned and function-checked beforehand, so that the window is fully available for the work itself. Discuss the transport route inside the building early — the bed lift or goods lift determines, through its car height and payload, which machine can reach an upper floor at all.

In these buildings the actual place of work is almost always the ceiling: medical gas and service runs, ventilation ducts, sprinkler pipes, ceiling supply units, lighting and the dense cable routing above it. Where the run is unobstructed, a scissor lift works most economically, because its platform carries material and two people and the section can be worked through without repositioning. If the working point sits behind a fixed installation — a ventilation plant room, a service duct, a ceiling bulkhead — the articulating boom lift takes the platform over the obstacle; in the electric version it covers 10.89 to 28.00 m at 150 to 280 kg platform capacity.

On the building envelope the picture is reversed. For ribbon windows, roof edge details, rooftop plant and the installation of solar shading on existing buildings, telescopic boom lifts with 14.00 to 56.90 m working height and 227 to 454 kg platform capacity reach the facade even across forecourts, access roads and green areas. Where the set-up area is unsurfaced or lawns and paths have to be protected, spider lifts with 13.00 to 39.50 m are the right choice. Take care not to place the set-up location on approach routes for emergency vehicles — with public service buildings that is the most frequent cause of last-minute rescheduling.

Class	Working height	Platform capacity
Scissor lifts, electric	6.30 – 33.00 m	227 – 1,000 kg
Scissor lifts, diesel	9.70 – 34.00 m	363 – 1,134 kg
High-rack scissor lifts	18.50 – 33.00 m	450 – 1,000 kg
Articulating boom lifts	10.89 – 48.15 m	150 – 450 kg
Telescopic boom lifts	14.00 – 56.90 m	227 – 454 kg
Mast lifts	10.00 – 12.65 m	200 kg
Spider lifts	13.00 – 39.50 m	200 – 400 kg

Alongside healthcare buildings, school complexes, sports facilities and commercial zones shape demand in Wetzikon — and there the task shifts from access at height to materials handling. Telehandlers cover this: rigid machines with 4.30 to 18.80 m lift height and 1.25 to 25 t capacity for delivery and repositioning on the site, roto models with 15.42 to 38.90 m and 4 to 8 t where loads have to go onto a flat roof across an existing building. For work in sports halls and assembly halls, electric telehandlers with 5.85 to 30.00 m and 2.5 to 7 t are available.

In civil engineering — service lines, external works, foundations for extensions — excavators from 1.8 to 30 t operating weight are used; the small classes are suitable for digging work in school yards and in the gaps between existing buildings. In the storage areas of the commercial zone, forklifts from 3 to 16 t and high-lift stackers with 2.70 to 5.50 m lift height and 1.2 to 2.0 t capacity supplement the fleet, for example during conversion phases with temporary interim storage.

Where third parties are in the building, the division of roles becomes the key question, and the operator's side asks for the paperwork before the first lift. Legally, Swiss law applies in Wetzikon: the basis is the Ordinance on the Prevention of Accidents and Occupational Diseases (VUV), implementation and supervision lie with SUVA, made specific by the directives of the Federal Coordination Commission for Occupational Safety (EKAS); above these stand the Labour Act and its associated ordinances. Mobile elevating work platforms are subject to recurring inspection in accordance with SN EN 280. Every hire machine leaves our premises with an inspection certificate, CE documentation and operating manual; with these, clearance by the technical department or the client can be evidenced. What cannot be transferred are the risk assessment for the specific assignment — in occupied buildings including cordoning off, escape routes and public circulation — the instruction of the operators and the visual and functional check before work begins.

As a traffic junction of the Oberland, Wetzikon is easy to reach; the difficulty lies with the time window, not with the route. At public service buildings we align the delivery with quiet periods and keep access routes clear for emergency and delivery traffic. Tell us with your enquiry where unloading is possible, whether the machine has to go to an upper floor via a lift — with the car dimensions and permissible payload — and which areas may not be driven on. For multi-stage building projects with several machines, we coordinate the scheduling with the locations in Zurich and Winterthur.

Rent aerial work platforms → | Request a quote →

Which aerial work platform is suitable for work in an occupied healthcare building?

An electric machine, and specifically the smallest one that reaches the working height. Electric scissor lifts from 6.30 m are locally emission-free, quiet and run on non-marking tyres. In cramped treatment and examination rooms, the mast lift with 10.00 to 12.65 m working height and 200 kg platform capacity is frequently the only option, because it fits through standard doors. Diesel machines are out of the question in such buildings.

How do I get an aerial work platform to an upper floor?

Via the goods lift or bed lift, if the car dimensions and permissible payload allow it. Tell us the clear car height, door width and load capacity and we will tell you which machine fits inside. If that is not possible, the route via the facade remains: a telescopic or articulating boom lift then works from outside, or a roto telehandler sets the machine down through an opening.

How is the assignment aligned with a fixed time window?

By having the machine already at the place of work before the window begins, cleaned and function-checked. We deliver at quiet periods by arrangement and take the machine back accordingly. It makes sense to plan bringing in, working and taking out as three separate steps and to set the hire period accordingly, instead of putting everything into one night.

Which machines reach ceiling services above fixed installations?

The articulating boom lift. Its platform is taken over the installation to the working point, whereas a scissor lift stops vertically in front of it. In the electric version, 10.89 to 28.00 m working height at 150 to 280 kg platform capacity is available. Where the run is unobstructed, by contrast, the scissor lift is more economical, because the larger platform takes material and two people.

What has to be considered for set-up areas on a hospital or school site?

Three points: the area must not block an approach route for emergency or delivery vehicles, it has to carry the outrigger load — on green areas and interlocking paving with spreader plates — and the working area has to be cordoned off from public circulation. For unsurfaced set-up locations we recommend spider lifts with 13.00 to 39.50 m, because they distribute their weight over the whole area.

Working height, outreach and ground conditions determine the right machine. A comparison of all designs with costs and inspection duties is available at Rent a lifting platform: platform types, costs and applications.